Six Forms Of Stainless Steel Pipe Fitting Processing Conversion

Six Forms Of Stainless Steel Pipe Processing Conversion

Stainless steel pipe fittings, like buttweld fittings are formed by machining and deformation of steel pipes. The following describes the various forms of processing and deformation of stainless steel pipe fittings as follows:

pipe-fittings-BW-stainless-steel

1. A tubular member having a flange and a rounded edge, the former means that the end of the pipe is convex toward the inside or the outside, and the latter refers to a pipe member which forms a bulge or a groove in the circumferential direction of the pipe;

2. The stainless steel elbow is changed into a thick stainless steel pipe fitting, and the wall thickness changes along the length of the pipe;

3, stainless steel elbow bending pipe fittings, we contact more, is to change the straight pipe into bends of different curvature radius, such as elbows, elbows, etc.;

4, stainless steel elbow variable diameter pipe fittings, the diameter of a part of the pipe end or pipe is reduced;

5. Pipe fittings with crimping and sealing type, which increase the total strength of the pipe end to the outer side or the inner side of the pipe or to seal the pipe end;

6, processing the cross section of the pipe, the circular section into a square, oval, polygon.

No Comments Yet.

If you have any requirement or comments, please do not hesitate to contact us or submit the table bellowing.